8 x AA battery holder with 5.5mm/2.1mm Plug and On/Off Switch
-
Description
Description-
Make a portable power brick with plenty of juice! Use Alkaline AA's for a 12V 3000-4000mAh power supply, or rechargeable NiMH for 2000mAh 9.6V supply. Either one is good for running electronics that have a 5V voltage regulator (thus requiring a 7V+ supply) or perhaps some motors or solenoids.
Perfect for portable Arduinos, motors, solenoids, 12V LED strips, etc. An On/Off switch lets you control the power right at the source without unplugging. Batteries not included, may or may not include screws. -
Technical Details
Technical Details+
-
Learn
Learn+
Next-generation light painting with NeoPixels and Arduino
2048x1536 Retina-Blasting Pixels in a 9.7" Display
Blast your tunes with a high-efficiency class D amplifier
Play tunes while you cruise in style
Stackable Steppers and DC motor control for your Raspberry Pi
Take epic timelapses with a DIY camera slider
An upgrade to the slider project
MAY WE ALSO SUGGEST...
MAY WE ALSO SUGGEST...-
-
Distributors+
See our Distributors page for a complete list of distributors.
Ordering full reels vs. cut reels
Adafruit NeoPixel Digital RGB LED strips come to us in 4 or 5 meter reels with a 2 or 3-pin JST SM connector on each end and separated power/ground wires as shown in the pic below. If you order a full 4 or 5 meters, you get the full reel with both connectors installed (like the pic below).
If you buy less than a full reel, you'll get a single strip, but it will be a cut piece from a reel which may or may not have a connector on it. If the piece comes from the end of the reel, the connector may be on the output end of the strip!
