Mini PIR Sensor with Time and Sensitivity Control - BS612

Product ID: 5578
Qty Discount
1-9 $1.95
10-99 $1.76
100+ $1.56


PIR sensors are used to detect motion from pets/humanoids from about 5 meters away (possibly works on zombies, not guaranteed). This sensor is much smaller than most PIR modules, which makes it great for unobtrusive projects. It's also fully contained and very configurable. After you've provided power and ground, you can use the remaining 3 pins to configure whether the sensor is enabled (OEN), how sensitive the PIR should be to motion (SENS) and how long the output is active for (ON TIME). Even though there are 6 pins, the wires are flexible and long so the sensor is breadboard or perfboard friendly.

Runs on 3.3V power - so make sure if you're interfacing with an Arduino or other 5V chip, you power it from the 3V regulator. The digital signal output is 3.3V high/low.

You can change the length of time the signal pin stays high by connecting a resistor divider to the ONTIME pin, from 2 seconds (0V) up to one hour (VDD a.k.a. 3.3V) - see the datasheet 'TIME pin voltage range center' table for recommended resistor values.

You can also change the sensitivity of the PIR element by connecting a resistor divider to the SENS pin, from 0V (most sensitive) to VDD/3.3V (least sensitive) - see the datasheet 'SENS pin voltage' table for details.

To use, see the datasheet pin-out diagram:

  • Connect pin #1 (SENSE) to ground (most sensitive)
  • Connect pin #2 (OEN) to 3.3V to enable the output
  • Connect pin #3 (VSS) to Ground
  • Connect pin #4 (VDD) to 3.3V
  • Check signal on pin #5 (REL)
  • Connect pin #6 (ONTIME) to ground (on time of 2 seconds)

The snap-on lens is focused to 5 meters away with a 120-degree spread but should work from about 3 to 8 meters. These are smaller and less expensive than our PIR modules, and you'll find the performance is OK but not as great as the larger modules, for example not having as wide of a range and taking longer to trigger.

For a PIR tutorial with CircuitPython and Arduino code examples and project ideas, check out our PIR sensor tutorial page!

The BS sensor window is 4mm x 3mm. We also carry the BL412 PIR sensor which has a larger sensing element (so it will be more sensitive) but does not have the extra configuration pins.

Play video: #NewProducts 8/24/2022 Featuring #Adafruit MAX17048 #LiPoly / #LiIon Fuel Gauge and Battery Monitor!

Technical Details

PIR sensors and the Raspberry Pi sometimes don't get along - if you're having false trigger reports, make sure the PIR Sensor is far away from the Pi

    RoHS 2 2011 65 EU Compliant
    RoHS 2 2015 863 EU Compliant