Search Results for "mini inverter"

A really tiny portable inverter for EL wire. Powers off of a single AAA battery (not included!), it can drive up to 50cm / 20 inches of our high-brightness EL wire or 10cm x 1cm long piece of EL tape for 3 hours (or longer if the EL wire is less than 50cm long). There is a switch on the side for selecting steady/blink/off modes. Comes with a 2.5mm pitch female JST...

A really tiny portable inverter for EL wire. Powers off of a single CR2032 coin battery (not included!), it can drive up to 50cm / 20 inches of our high-brightness EL wire or 10cm x 1cm long piece of EL tape for 3 hours (or longer if the EL wire is less than 50cm long). There is a button for selecting steady/blink/off modes. Comes with a 2.5mm pitch female JST...

Connect your DisplayPort and Mini DisplayPort sources and devices with this bi-directional cable! This cable has a standard sized DisplayPort (DP) connector on one end and a Mini DisplayPort (MDP) connector on the other. The cable is bi-directional, which means that you can use a DP source with a MDP monitor or a MDP source with a DP monitor. The conductors are made...

A versatile motor, servo, and audio driver HAT for Raspberry Pi. Bring your mechanical inventions, creations, and contraptions to life! Inventor HAT Mini helps transform a Raspberry Pi computer into a robot, prop, kinetic sculpture, creepy automaton, or any other exciting moving thing. Want to drive a couple of fancy motors with encoders (or hook up standard motors...

One can never have enough socks, or USB ports. Add some more USB capability to your Raspberry Pi Zero with the Zero4U! This is a 4-port USB hub for Raspberry Pi Zero, and it can be mounted back-to-back onto a Pi Zero. The 4 pogo pins on the back will connect the PP1, PP6, PP22 and PP23 testing pads on your Raspberry Pi Zero – no soldering required! This item...

The Raspberry Pi Build HAT (Hardware Attached on Top) is a new add-on board for your Raspberry Pi. It connects to the 40-pin GPIO header and can be used to control up to four LEGO Technic motors and sensors from the LEGO Education SPIKE Portfolio. The cool design of the Build HAT means that all the components are on the bottom, leaving room on the top of the board...

Your power supply problems just got SOLVED! These DC/DC converter step-down switching regulators are drop-in replacements for inefficient 78xx linear regulators. The little module may look tiny but inside is a high efficiency converter (up to 94%) which can output 1 Amp at 5V with up to +60°C ambient temperature without the need of any heat-sink or forced...

The Adafruit Sparkle Motion Mini is part of our series of "Sparkle Motion" boards, that are our attempt to make the best small WLED-friendly smart LED driving board in the whole world. Our resident mermaid, firepixie makes a lot of projects with WLED and she loves it! So how can we make something that will be powerful enough to drive advanced LED projects that need a...

With this handy 7 Pin Mini-DIN Connector you can now jack into the hackport on your iRobot and control it with an Arduino or some other favorite microcontroller that has a 5V TTL UART! You can also power your project off of the internal Create 2's battery. Note that the battery voltage can be as high as ~21V so a buck converter such as this one could be good for...

One of our star development boards is the Adafruit METRO Mini 328, an excellent lil fellow that lets you make your Arduino-based project tiny. Recently we had to redesign this board to move from the obsolete CP2104 to the available CP2102N, and one thing led to another, and before you know it we made a completely refreshed design: the Adafruit METRO Mini 328 V2. The...