Search Results for "flashing 5mm"

These are very interesting 5mm diffused RGB LEDs - instead of having 4 pins to control 3 LEDs, they have only two leads - power and ground. When powered, the LEDs perform a flashing effect with all the colors. See the video below for the timing and look. There is no way to change the 'program' or rate, its burned into a little chip that is inside the LED itself. If...

These are very interesting 5mm diffused RGB LEDs - instead of having 4 pins to control 3 LEDs, they have only two leads - power and ground. When powered, the LEDs perform a slow fade through the rainbow, from red to orange to yellow, etc till they get back to red. See the animated video above for the timing and look. There is no way to change the 'program' or rate,...

UUGear's Vivid Unit is a powerful and versatile single-board computer that can be used for a wide range of applications. It features an RK3399 CPU with 4GB RAM and 32GB eMMC storage. It is a palm-sized device with a 5.5″ capacitive touchscreen, speaker, microphone, WiFi/Bluetooth, and various interfaces. It can be powered with DC 5V (via USB-C) or an Ethernet...

A small, portable inverter for EL wire. Powers off of 2 AA batteries (not included!), it can drive 1 to 8 feet (about 2.5m) of our high-brightness EL wire for 10 hours. There is a button for selecting steady/blink/off modes. There's a removable clip on the back. Comes with a 2.5mm pitch female JST connector To connect a piece EL wire to this, you'll want a male...

This Multi-Hub Wheel is solid, a lil' chunky, but it won't make your robot bulky. It even comes in Adafruit black! Each order comes with one wheel and two different sized hubs to make connecting super quick and easy. The hubs may come attached to the wheel with a little plastic flashing, so you'll want diagonal cutters to trim them out or you can twist them out The...

You know those party platters you see at fancy events, where there's like sliced carrots on one side, and chunks of cheese on another, all divided up lovely? OK this is the exact same thing but for 6mm tactile buttons. You will never feel constrained by button colors again with this button party, lots of colors, in a handy carry case. Little clicky switches are...

*pew* *pew*! This board is like a little ray gun for infrared light, with two high powered LED outputs. When controlled with the onboard N-Channel FET driver, you'll be blasting 100mA-200mA of current pulsing through each LED for 10+ meters of range! This is the easiest way to get great IR emitter range without wiring up a bunch of parts. By using a 2mm pitch STEMMA...