Search Results for "10-pin idc"

This little 2x5 (10 pin - 0.1 spaced) IDC Breadboard Helper is great in conjunction with any of our 10-pin IDC cables. It comes in two parts, a 'pin-through' socket and a male header. The socket straddles the center of a breadboard or Perma-Proto and then header plugs into the top of the socket. Since IDC cables are so standard, but a royal pain to use with...

We don't really know what to call this thing - it's got a 10 pin IDC cable on one end 6 inches of rainbow ribbon and tipped with 0.1" female socket connectors on the ends. We think this would be handy as a 10-pin JTAG breakout adapter, or maybe some sort of cable re-arranger. Anyhow, it seems useful and we picked up a bunch. Yeah we know it would be awesome if we...

Connect this to that with an IDC cable! This cable has 10 pins (2x5) in 0.1"x0.1" spacing. Often used for programming AVRs. 6" long with two sockets crimped onto either side, they're quite sturdy!

Connect this to that with an IDC cable! This cable has 10 pins (2x5) in 0.1"x0.1" spacing. This is a shorter version of the cable we've carried for AVR programming, we use this for chaining together 16x24 LED matrix panels or GertBots About 1.5" long with two sockets crimped onto either side, they're quite sturdy!

These little cables are handy when programming or debugging a tiny board that uses 10-pin 1.27mm (0.05") pitch SWD programming connectors. We see these connectors often on ARM Cortex dev kits, and have a few handy in our ARM-dev box. We thought you may want a backup cable as well, so now they are in the Adafruit shop! One cable per order. The ribbon cable is...

These cables are handy when programming or debugging a tiny board that uses 10-pin 1.27mm (0.05") pitch SWD programming connectors. We see these connectors often on ARM Cortex dev kits and have a few handy in our ARM dev box. We thought you might want a backup cable as well, so now they are in the Adafruit shop! One cable per order. The ribbon cable is 0.06mm/0.025"...

This 1.27mm pitch, 2x5 male SMT Box Header is the same one used on our SWD Cable Breakout Board. The header alone is great if you want to incorporate this piece of hardware with your own software. We're specifically selling it so you can solder it onto our nRF52 Feather to add SWD debug/connect capabilities. You could also straighten out the SMT pins to solder into a...

We've carrying a new 1.27mm pitch 2x5 Mini SWD 0.05" Pitch Connector. It's a tinier, bite-sized version of the Box Header used on our SWD Cable Breakout Board. Instead of a full shroud, there's a half-shroud with a key-notch. It'll takes a lot less space on your board! The header alone is great if you want to incorporate this piece of hardware with your own software....

Ever wanted your microcontroller to sense images without eating up all your processor speed? Or wish that you had an image sensor that wasn't limited to RGB - but could sense hue and saturation as well? Or just want a kickstarted, open source camera sensor with a cool name? Enter the Pixy2 CMUCam5 - an image sensor for your microcontroller that you can teach what to...