Wearables / Accessories / Sewing

This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other tab is +3 Volts. This holder is meant to be used with Lithium CR2032...

If you'd like to connect a USB C connector to your favorite garment to make a fun wearable tech project, then try out the array of sewable connectors we have. This is a Type C connector that is oriented in a horizontal position to the sewable base it's housed on with red and black wires running through the bottom. The jack is molded into a rubber that can be hand or...

The small 5mm size of these tin-plated brass snaps means they fit perfectly on Flora's pads! Snaps make a great connector for wearables-- solder one side to the board and sew the other to your project with conductive thread! This card comes with 24 complete snaps (socket and stud pairs). Some discoloration may occur during soldering. These snaps are washable,...

Mighty needles, sew like the wind! This needle set is the only one you'll need for any sort of hand sewing, especially using our conductive thread and wearable electronics parts. Each pack contains 20 gold-eye sharps, with eye sizes ranging from #3 (1.75" long) to #9 (1.35" long). The two #3's (the largest) are too large to pass through the sewable coin cell holder...

These magnetic pin backs have two pieces: a metal bar with adhesive strip and a plastic piece with two strong rare-earth magnets. Affix the metal bar to your FLORA projects-- it's just the right size! Then attach your FLORA project to any garment without poking holes in your clothes. The magnets are strong enough to hold up even a hefty circuit! We recommend against...

This product's about as simple as a cup of lemonade on a hot summer day. And, like lemonade, it's just three components! This board is a sewable adapter with a 3-pin JST wiring adapter. It's a perfect way to add a simple link between things like our Flora NeoPixels and more complicated products like our NeoPixel Rings. There are three holes on the board that are...

If you'd like to connect a Micro-B connector to your favorite garment to make a fun wearable tech project, then try out the array of sewable connectors we have. This is a Micro-B connector that is oriented in a horizontal position to the sewable base it's housed on with red and black wires running through the bottom. The jack is molded into a rubber that can be hand...