There are so many great platforms for creating digitally enabled devices that its gotten hard to figure out which one to use. For example, we are currently building a hydroponic garden project and had to choose a controller to run the pumps, read the sensors etc. We were surprised at the number of choices that were available to us. It can be a little confusing for the beginner. To help, we’ve taken three of the popular models and compared them so that you can choose the right tool for your next project. Spoiler: we recommend all three.
The three models (all of which we use here at Digital Diner) are the Arduino,Raspberry Pi and BeagleBone. We chose these three because they are all readily available, affordable, about the same size (just larger than 2″ x 3″) and can all be used for creating wonderful digital gadgets. Before we get to the comparison, here is a brief introduction to each one.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7pm ET! To join, head over to YouTube and check out the show’s live chat – we’ll post the link there.
