Micro Servo - MG90D High Torque Metal Gear

Product ID: 1143
$9.95
Qty Discount
1-9 $9.95
10-99 $8.96
100+ $7.96

Description

Add more power to your robot with this metal-geared MG90D servo. The tiny little servo can rotate approximately 90 degrees (45 in each direction) and works just like the standard kinds you're used to but smaller. You can use any servo code, hardware, or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gearbox, especially since it will fit in small places. Of course, it's not nearly as strong as a standard servo. Works great with the Motor Shield for Arduino, our 16-channel Servo Driver, or by just wiring up with the Servo library. Comes with a few horns and hardware.

Please note, this servo will 'hold' the position even when no signal is sent!

To control with an Arduino, we suggest connecting the yellow control wire to pin 9 or 10 and using the Servo library included with the Arduino IDE (see here for an example sketch). Position "0" (1.5ms pulse) is middle, "90" (~2ms pulse) is all the way to the right, "-90" (~1ms pulse) is all the way to the left. The middle wire (orange or red) is +5V power, and the brown or black wire is Ground.

Note that the default servo pulse widths (usually 1ms to 2ms) will not give a full range of motion on this servo. We recommend using manual pulse lengths if possible: check if you can set your servo controller to custom pulse lengths and try 0.75ms to 2.25ms. You can try shorter/longer pulses but be aware that if you go too far you could break your servo, so slowly try a wider range to characterize the servo response!

Technical Details

Details:

  • Size : 22.8 x 12.2 x 28.5 mm
  • Voltage : 4.8V to 6V DC
  • Weight: 13.4 grams
  • Speed : 0.1 sec/60degrees (at 4.8V), 0.08 sec/60 degrees (at 6.0V)
  • Stall Torque : At 4.8V: 2.1 kg-cm / 25 oz-in. At 6.0V: 2.4 kg-cm / 30.5 oz-in
  • Spline Count: 20

Revision History:

  • As of November 7, 2018 this item has been updated to have a new digital 13g metal gear, with a double ball bearing servo.
RoHS 2 2011 65 EU Compliant
RoHS 2 2015 863 EU Compliant

Learn

Learn Arduino, Lesson 14. Servo Motors
Make tiny gear-motors for your next robot!
16 channels of servo-bustin' power for your Pi
for sanctioned UAV painting
See All Guides