adafruit_support wrote:The corner location of the GPIO header does not make for a stable stacking configuration. But if all the boards in the stack are protoboards, you can always add some stacking headers to some of the holes on the opposite corner for stability.
As for enclosures. I'm not aware of any that are designed for stacking. But the large waterproof enclosure in the store is plenty roomy and easily cut or drilled for cables etc.: https://www.adafruit.com/products/905
adafruit_support wrote:We have a few different kinds. You can replace the 2x13 GPIO header on your protoboard with the stacking variety. For the other corner, the smaller Arduino headers will probably work fine.
https://www.adafruit.com/index.php?main ... ing+header
Users browsing this forum: No registered users and 1 guest