While assembling the Timesquare watch I made an error that I believe should be correctable but I can't quite figure it.
While soldering in the LED matrix I think I must have damaged one of the through-hole connections, specifcally the 3rd pin from the battery, on the side with the Set Button. Everything else on the watch works brilliantly, except the 3rd row of LEDs does not light at all.
I'm am pretty sure it's my shaky hands that caused the issue, but it doesn't look like I've bridged any connectors, so if I can figure out what pin in the micro or a specific other point I can solder to I believe this should be bypass-able. Even without the one row I'm quite fond of this little watch so I would very much like to fix my error.
Thanks in advance,