I see you posted again before I finished composing my response to your
Why 4 buck-converters? Why not just one capable of 20-A?
GoVertical0017 wrote:I tried paralleling the mosfets and at higher amperage the board became hot
GoVertical0017 wrote:A 20 inductor is to expensive
GoVertical0017 wrote:I have had very good results with the 5 amp versions, it stays cool.
Almost. I would include a couple of blue LED's or zeners to put a limit to the voltage the CTs can put out.GoVertical0017 wrote:They interface the CT to the Arduino using just a 5 Kohm resistor, can it really be that simple??????
Users browsing this forum: No registered users and 2 guests