New Atmega chip

[Gapak]

But I still have a problem with burning the boatloader on a blank chip as described in my Dec 9 post.

[adafruit_support_bill]

OK. Let's start by checking your build. Post photos of the front & back of the shield.

[Gapak]

The two photos are on my desktop. How do I post them to my reply?

[adafruit_support_bill]

Use the "Upload Attachment" tab under the message edit box.

[Gapak]

Here are the two photos

166.jpg Ren2.jpg (73.54 KiB) Viewed 420 times

170.jpg Ren1.jpg (82.79 KiB) Viewed 420 times

[JD3]

One pin on the ZIF socket looks like it needs a little more solder -

Try re soldering the socket connections on pins 17 - 19 (yellow, orange, brown)
The socket pin that is connected to the yellow wire seems to need it the most.

[Gapak]

You know what JD3, you were right! I checked continuity between the inserting slots of the ZIF and the header pin; pin 17 was not connected. After resoldering bootloading worked fine.
Where did you get your eyesight from? congratulations and thank you very much for your help.

[JD3]

Well I tell you what, clear pictures being posted really help a lot

Plus i have one, so I compared the wiring to mine and the tutorial.
Everything looked great except that one spot