I ordered two el panels and an inverter from adafruit. The inverter that I received with the el panels has two separate connectors, one for each el panel. My set up it, I have two optoisolators, one is connected to pin 7 and one is connected in pin 6 on my arduino uno. Each optoisolator is connected to a triac. I also have a pushbutton. I have it set up so that when the pushbutton is high one panel is high and the other is low. However, what is happening that that they are both turning off. I am not sure how that inverter is set up but it seems like since there are two seperate wire then, each should be independent of each other. However, since they are both turning off I assume that they are in series.
Does anyone have anyway to wire it so that only one turned off instead of both?