Moderators: adafruit_support_bill, adafruit
by imaginerobots » Wed Jul 11, 2012 4:16 pm
by mikeselectricstuff » Wed Jul 11, 2012 4:53 pm
by imaginerobots » Wed Jul 11, 2012 5:08 pm
mikeselectricstuff wrote:Absolutely - the key is a good solder paste print. Alternativly use a line of paste on each edge, flow, and braid off the excess afterwards.
Return to SMT (Surface Mount Tech)
Users browsing this forum: No registered users and 1 guest