When you say the two center taps, how does one identify which are center taps? I have metered for resistance and have those wires which have continuity paired up and the break down I gave previously reflects that. I should also say that each pair reads the same resistance . So, I am assuming a+ a+ is one coil , a- a- is another coil and so on. If this is the case and all pairs exhibit the same resistance and continuity, how does one decipher which wires are center tap? I guess I am in the dark because I have made the connector for the motor, and other times I have been able to look up the pinouts based on wire color, and, I have never dealt with this type of unipolar motor before. Plus I have only dealt with a+a- pairings with two sets of the wires shorted to each other.
Thanks for the help