this is my first post and I expect it won't be the last
I have a problem with Adalight. I follow the instructions, but it seems like there are some "gremlin" in the installation.
Step by step: Microcode uploaded to the arduino board:
Processing running Swirlcolor:
Power supply connected:
Arduino connected to the ws2801 strip:
and power supply specs:
This is the behaviour of the setup. As installed, only the led closer to the data entry is lit.
If I "ground" the blue cable with my fingers, the LEDs blink as shown in this video (yes, that's me on the TV reflection
)http://imageshack.us/a/img35/2810/94cig ... fzsebu.mp4
And this is what happens if I plug the blue cable to the GNC pin of the board.http://imageshack.us/a/img11/5397/zgbhk ... aivdcv.mp4
My Arduino board is a Mega 1280. Is there anything different to bear in mind with this model?
Any ideas will be appreciated.
Thank you in advance!