I just received my first Arduino starter kit the ARDX V1.3.
A couple of points which I have found so far, some of which have been mentioned before in previous threads:
 Arduino Holder printed inversed. This mean that you have to place the breadboard and UNO on the reverse side to sync with the wiring guides.
 Assembly drawing (p.2) shows bolts entering from the top, whereas the online guide has the bolts entering from the bottom. Also the bolt attachment positions are different in the guide and the online guide. Either way, there is no easy fit. After experimenting and a lot of faff, I ended up with the top left bolt going in from the rear, and the bottom right going in from the top. You may have to snip the length after fitment as this may protrude too far and make the base uneven (after fitting the four rubber feet).
 The colour breadboard wiring diagram templates that came with the kit were too small for the 400 pin breadboard shipped with the kit! This was a great shame as this was a nice feature, which could help to explain and clarify the wiring for each exercise.
 There are no Red wires in the wire bundle, which is a big shame as I always teach Red (+ve) and Black (-ve) and insist that students follow this format! I have black, blue, yellow, orange, white and green. The next best I guess is to use white.
To prevent other users going through the same painful process of discovery, could these issues be rectified or al least a note made on the website, guide and online resources?
You have a really great product, which just needs a few tweaks to make it excellent!
Dr Stephen Prior.