New Plans To Store Wind Power In Salt Caverns #NatureAndTechnology
Groundbreaking technology may make it possible to store wind energy in salt mines. via calgaryherald
In the Lloydminster area, a Calgary company is ready to carve out large underground salt caverns to store excess wind energy — the first use of the technology in Canada.
Rocky Mountain Power president Jan van Egteren says the storage sites could be ready in five years.
Salt caverns have been used to store natural gas for years, but only two other projects in North America are using them for compressed air that is turned into electricity.
The caverns are carved out by pumping water deep down to dissolve the underground salt layer peculiar to the Lloydminster area.
Excess wind electricity would be used to pump compressed air into caverns about the size of a 60-storey building. The salt walls allow very little to escape. Then, when the wind dies, the compressed air is released and used to turn a generator to make electricity.
The cavern could store enough compressed air to provide electricity for five days to a city the size of Red Deer, says van Egteren.
“It could really help stabilize the grid by taking off power when the wind is really blowing.”
With Environment Minister Kyle Fawcett in Lima, Peru, for a critical round of international climate change talks, Alberta is taking a hard look at using more renewable energy to reduce its carbon emissions from coal-burning plants.
British Columbia, Quebec and Ontario also accompanied the federal delegation and Fawcett says Alberta is pushing for a common price on carbon across Canada and the U.S.
Meanwhile, the government stepped up efforts to find new technology to solve the critical problem of uneven wind power — those occasions when winds blow harder and create more power than is needed, or ramp up electricity too fast for the grid to handle.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7pm ET! To join, head over to YouTube and check out the show’s live chat – we’ll post the link there.
