NEW PRODUCTS – 16mm Illuminated Pushbuttons – Momentary and Latching On/Off Switch – A button is a button, a switch is a switch, and an LED is a LED, but these LED illuminated buttons are a lovely combination of all three! These are medium sized buttons, large enough to press easily but not too big that it gets in the way of your project panel. They have a built in LED that can be controlled separately from the switch action – either to indicate or just to look good.
The body is a black plastic with the LED built inside. There are two contacts for the button and two contacts for the LED, one marked + and one -. The forward voltage of the LED is about 2.2V so connect a 220 to 1000 ohm resistor in series just as you would with any other LED to your 3V or higher power supply.
The button shown above has a red body and LED and is momentary, normally open. The two switch contacts are not connected normally. When you push the button they will temporarily connect until the button is released. The LED is separated from the button, so you can make it light up when pressed, light up when not pressed, always lit, etc.
This particular button shown above has a yellow body and LED and is latching on/off. The two switch contacts are either connected or disconnected. When you push the button they will switch from one to the other, like an on-off switch. The LED is separated from the button, so you can make it light up when on, light up when off, always lit, etc.
- Max Dimensions: 18.06mm / 0.7″ x 18mm / 0.7″ x 29.4mm / 1.15″
- Shaft Dimensions: 14.89mm / 0.58″ x 15.56mm / 0.6″ x 18.7mm / 0.73″
- Button Height: 5mm / 0.2″
- Button Height Depressed: 3.5mm / 0.15″
- Weight: 4.6g
No comments yet.
Sorry, the comment form is closed at this time.