July 12, 2013 AT 5:30 am

Low-profile microSD card adapter for Raspberry Pi #piday #raspberrypi @Raspberry_Pi


Featured Adafruit Products

Low-profile microSD card adapter for Raspberry Pi – Make your Pi a little slimmer with this microSD card adapter board. It slides in where the SD card goes but is half the length. Pop in a microSD card for a sleeker machine. The microSD card holder is a push-push type so you can push on the edge that sticks out to remove the card when necessary.

MicroSD card and Raspberry Pi NOT INCLUDED. Depending on the case from various manufacturers, the microSD card adapter may not easily slide in and out or may need modifications to the PCB or actual case. The microSD card adapter is meant for a stand alone board or with use on our Pi Dish or VESA mount. It does not fit in a PiBow case, for certain. You might be able to build an Adafruit Pi Box around a Pi with the adapter inserted but it isn’t a good fit and the card can’t be ejected while installed and it’s not recommended to be used with the Pi Box. Other cases may or may not work, so be aware before assuming that this will work with your case!

In stock and shipping now!


998Each Friday is PiDay here at Adafruit, be sure to check out our posts, tutorials and new Raspberry Pi related products. Have you tried the new “Adafruit Raspberry Pi Educational Linux Distro”? It’s our tweaked distribution for teaching electronics using the Raspberry Pi. But wait, there’s more! Try our new Raspberry Pi WebIDE! The easiest way to learn programming on a Raspberry Pi.

We now have Raspberry Pi Model B with 512MB RAM in stock and shipping now!


Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground”Adafruit’s Apps!



No Comments

No comments yet.

Sorry, the comment form is closed at this time.