Happy Halloween from Adafruit! Check out some scary #electronichalloween posts, the frightening Halloween section and spooky videos!

May 24, 2013 AT 6:49 pm

NEW PRODUCT – VS1053 Codec + MicroSD Breakout – MP3/WAV/MIDI/OGG Play + Record

1381_LRG

NEW PRODUCT – VS1053 Codec + MicroSD Breakout – MP3/WAV/MIDI/OGG Play + Record – This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can also be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. You can do all sorts of stuff with the audio as well such as adjusting bass, treble, and volume digitally. There is also 8 GPIO pins that can be used for stuff like lighting up small LEDs or reading buttons.

1381use_LRG

All this functionality is implemented in a light-weight SPI interface so nearly any microcontroller can play audio from an SD card. There’s also a special MIDI mode that you can boot the chip into that will read ‘classic’ 31250Kbaud MIDI data on a UART pin and act like a synth/drum machine – there are dozens of built-in drum and sample effects! But the chip is a pain to solder, and needs a lot of extras. That’s why we spun up the best breakout, perfect for use with an Arduino but also good for other microcontrollers that just don’t have the computational power to decode MP3s.

1381back_LRG

The breakout is slim enough to fit on a breadboard with 1 row of holes left over for wiring. There’s 3.3v and 1.8v regulators onboard with ferrite beads and analog filtering for quality analog output. There’s a microphone input port that you can wire up a line-in or mic to and record compressed audio. All 8 GPIO are broken out and they all have built in 100K pulldowns, simply connect your button from the GPIO pin to 3.3V for an active-high connection. You’ll likely want to play music from a microSD card so we added a holder on-board. And since we know so many of our customers use 5V microcontrollers like the Arduino, we made the interface pins all 5V compliant with level shifters so you can use the chip at 3V or 5V power/logic!

Each order comes with a fully assembled and tested breakout board, some 0.1″ male header you can solder to the breakout so it plugs into a breadboard and a bonus stereo headphone jack that will be handy when you want to plug headphones in!

In stock and shipping now!


Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground”Adafruit’s Apps!



No Comments

No comments yet.

Sorry, the comment form is closed at this time.