The amazing InMoov project is on the front cover of the next issue of The Atlantic Magazine.  Too bad the article is about robots in general, and not about the InMoov project itself.

A few months ago I was asked by an American set designer, if I would let them use InMoov hand for to make the front cover of The Atlantic magazine.
Attribution is to be expected inside the magazine. Behing abroad, I have not the chance to buy it for to check it out.

Looking at the result, they did a good job on the finishing touch. If I remember correctly, it was printed in PLA with a 0.3mm thickness. They did a finishing coating with paint, but I would guess they had to use a primer with a good sending job.

Check out the InMoov project on Thingiverse, and print your own!