Printable catalog (PDF)
Check out this great acrylic cut case for the Adafruit 3.5″ LCD, from jp kelly, Thingiverse Thing 41751 from the Adafruit forums!
This is a protective case for the NTSC LCD screen listed here on Adafruit.
It is designed like the PiBow in layers.
The parts are pretty delicate when you cut them but when put together it is a lot stronger than the LCD panel by itself.
Instructions
Use 1/16 “ acrylic.
I split cutting into 3 layers to allow cooling and to keep all holes in place until outside cut is made.
Parts 4 and 5 require you to fit the controller board through the slot.
4 Small holes on outside edge are for 3/4” x 2-56 screws.
FEED
