If you are in the New York City area this weekend, there are still a couple of slots open at the NYC Resistor TIMESQUARE watch class for this weekend!.
Have you ever wanted to wear an Arduino on your wrist and tell the time with a giant LED matrix? Then you’ll love this three hour class at NYC Resistor that I’ll be teaching on February 9th. During the class you can learn how to solder through-hole components as we put together the Adafruit Timesquare DIY watch kit, and afterwards we will extend the watch firmware to add a new feature to the watch.
This class is a great introduction to soldering and some advanced embedded programming techniques. The coin-cell powered Timesquare watch isn’t exactly a normal Arduino and is very CPU limited, so techniques for limiting power consumption, waking up from deep sleep with interrupt handlers, low voltage brownout detection and some inline AVR assembly will be discussed. If you just want to learn to solder and have a very stylish wristwatch, you don’t have to stay for the walkthrough of the firmware.
Included in the class price for every student is a pre-programmed Adafruit Timesquare watch kit and an FTDI cable for re-programming it (a $49 value). You’ll need to bring your own laptop with the Arduino IDE installed to flash new firmware onto the device if you are staying for the advanced portion of the class.
Featured Adafruit Products!
TIMESQUARE DIY Watch Kit – Red Display Matrix: Show up stylish AND on time to any event with this awesome looking DIY watch. We have a few watch kits here at Adafruit but we finally have one that looks good and fits well, even for ladies and kids and others with smaller wrists and hands. Its got a 8×8 bit matrix display and a repurposed silicone watch band for a professional look.
64 LEDs light up to tell you the time in a variety of ways. Built into the kit are 3 different watch ‘faces’ – a scrolling marquee with time and date, a binary watch display (for geeks, robots and binary fans), and a moon phase display (for beach-combers, werewolves). There’s also a built in battery meter so you can check your battery life. Want to make your own watch? Easy! The microcontroller is an Arduino-compatible, all you need is an FTDI Friend and the Arduino IDE and you can design your own watch faces and upload them to the TIMESQUARE. (read more)
3D Printed Watch Body for the TIMESQUARE DIY Watch Kit: Love the TIMESQUARE DIY Watch kit and have a great idea for a custom watch body you would like to fabricate to house the electronic parts? The watch kit already ships with style to spare, but that’s no reason to limit yourself to the included watch band when you can make one. Here are the steps I took to create the “Circling the Square” TIMESQUARE Watch Body. As I guide you through the steps I followed, I will share plenty of tips and tricks for how you can design your own! (read more)Related