The Pi T-Cobbler is supplied in 4 parts (plus a ribbon cable to connect it to the Raspberry Pi) which require soldering together; the PCB, the 26 pin IDC header and two 13 pin connectors .
Soldering the item is quite simple.
- Fit the pin headers first, so that you can hold them flat on the desk while you solder.
- It is helpful to solder one pin on each end and then check that everything is flat, level and nicely aligned).
- Check carefully for any joints which have too little solder, or any which may have too much joining pins together.
There are lots of pins to solder, but it is great soldering practise since it is only plastic which will melt if you over heat it (rather than the risk of damaging components). Just take a little bit of care since it can be a little small and fiddly to hold, and the pins will stay hot.
Featured Adafruit Products!
Adafruit Pi T-Cobbler Breakout Kit for Raspberry Pi: Now that you’ve finally got your hands on a Raspberry Pi® , you’re probably itching to make some fun embedded computer projects with it. What you need is an add on prototyping Pi T-Cobbler from Adafruit, which can break out all those tasty power, GPIO, I2C and SPI pins from the 26 pin header onto a solderless breadboard. This mini kit will make “cobbling together” prototypes with the Pi super easy. Designed for Raspberry Pi Model B Revision 1 or Revision 2. (read more)
Each Friday is PiDay here at Adafruit, be sure to check out our posts, tutorials and new Raspberry Pi related products. Have you tried the new “Adafruit Raspberry Pi Educational Linux Distro” ? It’s our tweaked distribution for teaching electronics using the Raspberry Pi. But wait, there’s more! Try our new Raspberry Pi WebIDE! The easiest way to learn programming on a Raspberry Pi.
Want a FREE RASPBERRY PI? All orders over $350 get a FREE Raspberry Pi Model B with 512MB RAM!Related
No comments yet.
Sorry, the comment form is closed at this time.