For quite some time I had my Raspi lying around. And some RGB Pixels as well. So it was about time to bring them together. The last couple of days I built a web interface that I can use to control my pixels. That’s more a technical demo, rather than something useful. But I learned quite a bit.
RGB Pixels are digitally-controllable lights you can set to any color, or animate. Each RGB LED and controller chip is molded into a ‘dot’ of silicone. The dots are weatherproof and rugged. There are four flanges molded in so that you can ‘push’ them into a 12mm drill hole in any material up to 1.5mm/0.06″ thick. They’re typically used to make outdoor signs. We also have flat-backed pixels that are essentially the same, but are not as long and thin.
Each Friday is PiDay here at Adafruit, be sure to check out our posts, tutorials and new Raspberry Pi related products. Have you tried the new “Adafruit Raspberry Pi Educational Linux Distro” ? It’s our tweaked distribution for teaching electronics using the Raspberry Pi. But wait, there’s more! Try our new Raspberry Pi WebIDE! The easiest way to learn programming on a Raspberry Pi.
Want a FREE RASPBERRY PI? All orders over $350 get a FREE Raspberry Pi Model B with 512MB RAM!Related
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
No comments yet.
Sorry, the comment form is closed at this time.