October 25, 2012 AT 5:14 pm

NEW PRODUCTS! Configurable Spring Terminal Blocks – 5 pack

1074 LRG

NEW PRODUCTS! Configurable Spring Terminal Blocks – 5 pack in “straight” or “right angle” style. Spring terminal blocks will simplify your wiring and make your project more rugged. Instead of soldering wires to your perf board, solder in these 0.1″ pitch terminal blocks. There’s a little spring contact so you can pull back on the plastic bit and slip in your 20 to 26 AWG solid or stranded-core wires. Each terminal block is electrically isolated from those next to it. Each block also has two solder pins per contact for strong mechanical strength when soldering in place.

1081reconfiguring LRG

What we like about these terminal blocks is that they are re-configurable! The pack comes in a set of 5 pieces of 3-pin blocks. However, by carefully removing the end cap on each one you can snap together any number and then reattach the end cap. So you could use this to have 5 x 3 pin contacts, or 1 x 15 pin contact, or 3 x 5 pin contacts, etc. Keep these around in your toolkit, and arrange them as needed!

1081group LRG

These are a really great accompaniment to our PermaProto boards.

1081 LRG

These are the “straight” style – the wires go in from the top.

1074step3 LRG

We also have “right angle” style if you want the wire to go in from the side.

In stock and shipping now!

Related

2 Comments

  1. I’m unsure if you can really reconfigure them into three 5-pin modules – it doesn’t look like they disassemble that far. I think the only options are multiples of three pins.

  2. Pavel, you can configure them into any number you wish – each contact can disconnect

Sorry, the comment form is closed at this time.