The LightScythe is a device for writing text and images frozen in midair. The hardware information and software is open source and anyone can make it… Uses our digital LED strip.
These LED strips are fun and glowy. There are 32 RGB LEDs per meter, and you can control each LED individually! Yes, that’s right, this is the digitally-addressable type of LED strip. You can set the color of each LED’s red, green and blue component on/off and fade between colors. The LEDs are controlled by shift-registers that are chained up down the strip so you can shorten or lengthen the strip. 3 digital output pins are required to send data down.
The strip is made of flexible PCB material, and comes with a waterproof sheathing.
You can cut this stuff pretty easily with wire cutters, there are cut-lines every 2.5″/6.2cm (2 LEDs each). Solder to the 0.1″ copper pads and you’re good to go. Of course, you can also connect strips together to make them longer, just watch how much current you need! We have a 5V/2A supply that should be able to drive 1 or more meters (depending on use)
They come in 5 meter reels with a 0.1″ molexy connector on the end, and are sold by the meter! If you buy 5m at a time, you’ll get full reels. If you buy less than 5m, you’ll get a single strip, but it will be a cut piece from a reel which may or may not have a connector on it.
- 19mm (0.75″) wide, 4.5mm (0.18″) thick with casing on, 62.5mm (2.45″) long per segment
- 32 LEDs per meter
- Removable IP65 waterproof casing
- Maximum 5V @ 120mA draw per 2.5″ strip segment (all LEDs on full brightness)
- 2 common-anode RGB LEDs per segment, individually controllable
- LED wavelengths: 630nm/530nm/475nm
- HL1606 LED controller chip with ‘SPI’-like protocol
No comments yet.
Sorry, the comment form is closed at this time.