Summer means tank-tops, air-conditioner installation and new kits!

This kit is something I’ve wanted for a while. Its an all-through-hole USB AVR programmer for a bit over $20, with both 6 and 10 pin cables and a jumper for powering the target board from the USB hub’s 5V power. It can also be used with SpokePOV kits to upload images and configuration (finally!)

I’ve had a bunch out there in the wild for a few weeks so I’m feeling comfy with an official release.
Check out the deets at the USBtinyISP page

A simple open-source USB AVR programmer and SPI interface. It is low cost, easy to make, works great with avrdude, is AVRStudio-compatible and tested under Windows and MacOS X. Perfect for students and beginners, or as a backup programmer.

The project is based off of the USBtiny code & design. The main improvements are: adjusting the code to allow it to act as a SpokePOV interface, adding lowlevel bitbang commands, and addition of a “USB good” LED. Other changes are new VID/PID (to make it official), removing some of the commands, and moving around the pins a bit.

You can build this design using the schematic and firmware, or buy a kit from the Adafruit webshop. Having a full kit available solves the “chicken & egg” problem of purchasing or building a USB programmer that then needs a programmer of some sort to ‘kick start’. (See USBasp, AVRdoper, USBprog)

All the firmware code is distributed under the GPL, the hardware design layout files are CC 2.5 Attrib./Share-alike